Chapter 1. Start Service 1-29
12–13 Additional Sense Code (ASC)
Additional Sense Code Qualifier (ASCQ)
Byte 12 Byte 13
ASC ASCQ
2C 00 Command sequence error
2F 00 Commands cleared by another initiator
30 00 Incompatible medium installed
30 01 Cannot read medium, unknown format
30 02 Cannot read medium, Incompatible format
30 03 Cleaning in process
30 05 Cannot write medium, Incompatible format
31 00 Medium format corrupted
31 01 Format command failed
33 00 Tape length error
37 00 Rounded parameter
39 00 Saving parameters not supported
3A 00 Medium not present
3B 00 Sequential positioning error
3B 08 Repositioning error
3D 00 Invalid bits in ID message
3F 01 Microcode has been changed
3F 02 Changed operating definition
3F 03 Inquiry data has changed
40 00 Diagnostic failure
43 00 Message error
44 00 Internal target failure
45 00 Select/reselect failure
47 00 SCSI parity error
47 80 Read internal CRC error
47 81 Write internal CRC error
48 00 IDE message received
49 00 Invalid message error
4A 00 Command Phase error
4B 00 Data phase error
4C 00 Logical Unit failed self-configuration
4E 00 Overlapped commands attempted
50 01 Write append position error (WORM)
51 00 ERASE failure
52 00 Cartridge fault
53 00 Media load or eject failed
53 01 Unload tape failure
53 02 Media removal prevented
5A 01 Operator medium removal requested
5B 02 Log counter at maximum
5B 03 Log list codes exhausted
5D 00 Failure prediction threshold exceeded
5D FF Failure prediction threshold exceeded (false)
80 00 CU mode, vendor-unique
82 83 Drive has been cleaned (old version of microcode)
83 83 Drive has been cleaned
85 00 Write protected because of Tape or Drive failure
85 01 Write protected because of Tape failure
85 02 Write protected because of Drive failure
85 03 Write protected because of current tape position
Table 1-9. Tape drive sense data (continued)
Byte
Bit Address or Name
76543210
To Next Page
Loading...
