Scan set mode
When the squelch is open, the scan continues until it is
manually stopped — it does not pause on detected sig-
nals. When the squelch is closed, the scan stops when
a signal is detected, then resumes according to the
Scan Resume setting. The scan speed and the Scan
Resume setting can be set in the Scan set mode.
The Multi-function screens are OFF.
Push [SCAN](F). q
• The Scan screen is displayed.
Push [SET](F). w
• The Scan set screen is displayed.
Push [ e p](F) or [q](F) to select the desired item.
Rotate [MAIN DIAL] to select the desired setting. r
• Hold down [DEF](F) for 1 second to select the default
setting.
Push [EXIT/SET]. t
Exits the Set screen.
SCAN Speed (Default: HIGH)
Set the desired scan speed to high or low.
• HIGH: Scan is faster
• LOW: Scan is slower.
SCAN Resume (Default: ON)
Set the scan resume function to ON or OFF.
• ON: When a signal is detected, scan pauses for
10 seconds, then resumes. Two seconds after
the signal disappears, the scan resumes.
• OFF: When detecting a signal, cancels scanning.
To Next Page
Loading...
