Icom IC-7851 - When first applying power

4-2
4
BASIC OPERATION
wer
t
y
u
o
q
i
!0
!1
!2 !3 !4 !5 !6 !7
!8
!9
@0
No. Control Position No. Control Position
q
DELAY control Fully counterclockwise
!1
MONI GAIN control 12 o'clock
w
KEY SPEED control Fully counterclockwise
!2
COMP control 12 o'clock
e
RF PWR control Fully clockwise
!3
DRIVE control 12 o'clock
r
MIC control 12 o'clock
!4
VOX GAIN control 12 o'clock
t
AGC control 12 o'clock
!5
ANTI VOX control 12 o'clock
y
SQL control Fully counterclockwise
!6
CONTRAST control 12 o'clock
u
NR control Fully counterclockwise
!7
BRIGHT control 12 o'clock
i
NB control Fully counterclockwise
!8
CW PITCH control 12 o'clock
o
AF control Fully counterclockwise
!9
NOTCH control 12 o'clock
!0
RF control Fully clockwise
@0
DIGI-SEL control 12 o'clock
All keys of this transceiver are non lock type.
When turned ON, the transceiver starts with all keys' status as they were previously set. However, the [TRANSMIT]
key always in the OFF (receive) condition at power ON.

When rst applying power
Before first applying power, confirm the following con-
nections or settings:
• Antennas are properly connected. (p. 3-4)
• A ground wire is properly connected. (p. 3-2)
• External devices such as a liner amplier, if used, are
properly connected. (pp. 3-5~3-7).
• All controls are set as shown below.