Icom IC-7851 - Setting Select Memory Channels; Setting in the Scan Screen; Setting in the Memory List Screen; Erasing the Select Scan Setting

12-8
12
SCANS
D
Setting in the Scan screen
 The Multi-function screens are OFF.
Push [V/M]. q
• Selects the Memory mode.
• Pushing [V/M] toggles between the VFO and Memory
modes.
e Push [SCAN](F).
• The Scan screen is displayed.
r Select the desired memory channel to set as a Se-
lect memory channel.
• The [p] or [q] keys and direct keypad selections can be
used.
Push [SELECT](F) several times to set the memory t
channel as a Select memory 1, 2, 3 or not.
Repeat steps y r to t to program another memory
channel as a Select memory channel, if desired.
Push [EXIT/SET] u
• Exits the Scan screen.
D
Erasing the Select scan setting
 The Multi-function screens are OFF.
Push [MEMORY](F) to enter the Memory list screen, q
or push [SCAN](F) to enter the Scan screen.
Hold down [SELECT](F) for 1 second to display the w
Memory select all clear window.
Push one of the following keys to clear all Select e
channel settings.
[1](F): Clears all 1 settings.
[2](F): Clears all 2 settings.
[3](F): Clears all 3 settings.
[1,2,3](F): Clears all Select settings.
Push [EXIT/SET]. r
• Exits the Memory list screen.
D
Setting in the Memory list screen
 The Multi-function screens are OFF.
Push [MEMORY](F) q
• The Memory list screen is displayed.
Rotate [MAIN DIAL] while pushing [ROLL](F) or w
[SET](F) to select the desired memory channel.
• The [p] or [q] keys and direct keypad selections can
also be used.
Push [SELECT](F) several times to set the memory r
channel as a select memory 1, 2, 3 or not.
Repeat steps t e to r to program another memory
channel as a Select memory channel, if desired.
Push [EXIT/SET]. y
• Exits the Memory list screen.
• Setting the Select memory channels
• Setting the Select memory channels
•
Erasing the Select memory channel scan settings

Setting Select memory channels