Icom IC-7851 - Fine Programmed Scan

12-6
12
SCANS
• While scanning
BlinksBlinks

Fine Programmed scan
In the Fine Programmed scan, the scan speed de-
creases when the squelch opens, but the transceiver
keeps scanning. The scanning tuning step changes to
10 Hz when the squelch opens.
 The Multi-function screens are OFF.
Push [SCAN](F). q
• The Scan screen is displayed.
Set for a Programmed scan as described on w page
12-5.
Push [PROG](F). e
• The Programmed scan starts.
• “
PROGRAM SCAN
” and decimal points blink while scan-
ning.
Push [FINE](F). r
• The Fine programmed scan starts.
• “
FINE PROGRAM SCAN
” blinks.
• Push [FINE](F) to release the Fine Programmed scan.
• Push [PROG](F) to cancel the scan
• Rotating [MAIN DIAL] also cancels the scan.
• Hold down [RECALL](F) for 1 second to recall the fre-
quencies that are set before starting the scan (P1 and
P2), if desired.
When the scan detects a signal, the scan speed de-
creases but the scan does not stop.
[MAIN DIAL]
[TS][V/M]
[EXIT/SET]
Mode keys
(F) Function keys