Icom IC-7851 - CC Set Screen; Display Set Screen; Ref Adjust

15-10
15
SET MODE
LCD Unit Bright (Default: 50%)
Adjusts the LCD brightness.
• Range: 0 (dark) to 100% (bright) (in 1% steps)
Backlight (Switches) (Default: 80)
Adjusts the key backlight brightness.
• Range: 1 (dark) to 100 (bright) (in 1 steps)
Display Type (Default: A)
Sets the display type to A or B.
Display Font (Default: Basic (1))
Selects the font for the frequency readout.
• Options: Basic (1), Basic (2), Basic (3), Italic (1), Italic
(2), Italic (3), Round (1), Round (2), Round (3)
Meter Response (Default: MID)
Sets the meter needle response speed to SLOW, MID
or FAST.
Meter Type (Normal Screen)
(Default: Standard)
Sets the S/RF meter type for the normal display to
Standard, Edgewise or Bar.
Meter Type (Expand Screen) (Default: Bar)
Sets the S/RF meter type for the expanded display to
Standard, Edgewise or Bar.
Meter Peak Hold (Bar) (Default: ON)
Turns the meter peak hold function ON or OFF.
Memory Name (Default: ON)
Turns the memory name indication in the memory
mode ON or OFF.
• ON: The programmed memory name is displayed
above the frequency display.
• OFF: Memory name is not displayed, even if en-
tered.

Display set screen
External Meter Level (M) (Default: 50%)
Sets the output level to the external meter (Main band).
• Range: 0%–100% (in 1% steps)
• Approximately 1.2 V (full-scale) at the 50% (default) setting.
(impedance: 4.7 kΩ)
External Meter Level (S) (Default: 50%)
Sets the output level to the external meter (Sub
band).
• Range: 0%–100% (in 1% steps)
• Approximately 1.2 V (full-scale) at the 50% (default) setting.
(impedance: 4.7 kΩ)
REF IN/OUT (Default: OFF)
Selects the transceiver’s reference frequency signal source.
• IN: Uses an external reference signal.
Turn OFF the power, and then turn ON to make
the setting effective.
NOTE: If the applied reference signal is off
frequency, or no signal is applied, the IC-
7851 will not properly operate. In that case,
select “OFF” or “OUT,” and then reboot the
IC-7851
• OFF: Does not input/output the reference signal.
• OUT: Outputs the internal reference signal to the
connected equipment(s).
REF Adjust
Adjusts the internal reference frequency.
• Range: 0%–100% (in 1% steps)
NOTE: The default setting differs slightly, depending
on the transceiver.
 ACC set screen (continued)