ITEMS DESCRIPTIONS RANGE OR VALUE REF.
SSB RX HPF/LPF HPF (High-Pass Filter)/LPF (Low-Pass Fil-
ter) cut-off frequency setting for the received
audio in SSB mode.
HPF 100Hz ~ 2000Hz
LPF 500Hz ~ 2400Hz
p. 15-4
SSB RX Tone (Bass) RX Tone level setting
for SSB.
Bass –5~+5 (in 1 digit steps)
SSB RX Tone (Treble) Treble
AM RX HPF/LPF HPF (High-Pass Filter)/LPF (Low-Pass Fil-
ter) cut-off frequency setting for the received
audio in AM mode.
HPF 100Hz ~ 2000Hz
LPF 500Hz ~ 2400Hz
AM RX Tone (Bass) RX Tone level setting
for AM.
Bass –5~+5 (in 1 digit steps)
AM RX Tone (Treble) Treble
FM RX HPF/LPF HPF (High-Pass Filter)/LPF (Low-Pass Fil-
ter) cut-off frequency setting for the received
audio in FM mode.
HPF 100Hz ~ 2000Hz
LPF 500Hz ~ 2400Hz
FM RX Tone (Bass) RX Tone level setting
for FM.
Bass –5~+5 (in 1 digit steps)
FM RX Tone (Treble) Treble
CW RX HPF/LPF HPF (High-Pass Filter)/LPF (Low-Pass Fil-
ter) cut-off frequency setting for the recep-
tion.
HPF 100Hz ~ 2000Hz
LPF 500Hz ~ 2400Hz
RTTY RX HPF/LPF
PSK RX HPF/LPF
SSB TX Tone (Bass) TX Tone level set-
ting.
Bass –5~+5 (in 1 digit steps)
SSB TX Tone (Treble) Treble
AM TX Tone (Bass) Bass
AM TX Tone (Treble) Treble
FM TX Tone (Bass) Bass p. 15-5
FM TX Tone (Treble) Treble
SSB TBW (WIDE) Transmission passband width setting for the
"WIDE" selection.
Lower freq. :
100, 200, 300 and 500 Hz
Higher freq. :
2500, 2700, 2800
and 2900 Hz
SSB TBW (MID) Transmission passband width setting for the
"MID" selection.
SSB TBW (NAR) Transmission passband width setting for the
"NAR" selection.
Speech Level Voice synthesizer audio output level set-
ting.
0~100% (in 1% steps)
Side Tone Level CW side tone output level setting. 0~100% (in 1% steps)
Side Tone Level Limit CW side tone output level limit function set-
ting.
OFF, ON
APF AF Level Audio output level setting while APF is
used.
0~+6 dB (in 1dB steps)
Beep Level Beep audio output level setting. 0~100% (in 1% steps)
Beep Level Limit Sets the limit of the beep output level. OFF, ON
Phones Level Ratio setting for audio output level from the
headphone toward to the internal speaker.
–15~+15 (in 1 digit steps)
Phone L/R Mix Main/Sub bands audio mix output setting to
the headphone.
OFF, ON
LEVEL SET
SET [F-7]
LEVEL [F-1]
To Next Page
Loading...
