ITEMS DESCRIPTIONS RANGE OR VALUE REF.
USB Output Select [USB B] Output signal setting. AF, IF p. 15-7
USB AF/IF XFC Output (SPLIT
ON)
Band selection for the
AF/IF signal output while
holding down [XFC] dur-
ing split operation.
MAIN, SUB
USB AF Output Level AF Output Level setting. 0~100% (in 1% steps)
USB AF SQL Squelch relation setting
when the AF signal out-
put is set.
OFF(OPEN), ON
USB AF Beep/Speech... Output Beep and voice synthe-
sizer audio output setting
when the AF signal out-
put is set.
OFF, ON
USB IF Output Level IF Output Level setting. 0~100% (in 1% steps) p. 15-8
LAN Output Select [LAN] Output signal setting. AF, IF
LAN AF SQL Squelch relation setting
when the AF signal out-
put is set.
OFF(OPEN), ON
ACC-A MOD Level [A ACC1] Modulation signal input
level.
0~100% (in 1% steps)
ACC-B MOD Level [B ACC1]
S/PDIF MOD Level [S/P DIF]
USB MOD Level [USB B]
LAN MOD Level [LAN]
DATA OFF MOD Modulation input
connector selec-
tion.
When data mode is not
in use.
MIC,
ACC-A,
ACC-B,
MIC,ACC-A,
MIC,ACC-B,
ACC-A,ACC-B,
MIC,ACC-A,ACC-B,
S/PDIF,
USB,
LAN
DATA1 MOD When data 1 mode (D1)
is in use.
DATA2 MOD When data 2 mode (D2)
is in use.
DATA3 MOD When data 3 mode (D3)
is in use.
p. 15-9
ACC-A BAND Voltage Output [A ACC2] Band selection for the
band control signal.
MAIN, SUB, TX
ACC-B BAND Voltage Output [B ACC2]
SEND Relay Type SEND relay type setting. Reed, MOS-FET
External Meter Output (M) Output signal set-
ting from [METER].
MAIN Auto, S(MAIN), Po, SWR,
ALC, COMP, VD, ID
External Meter Output (S) SUB Auto, S(SUB), Po, SWR, ALC,
COMP, VD, ID
External Meter Level (M) MAIN 0~100% (in 1% steps) p. 15-10
External Meter Level (S) SUB
REF IN/OUT [REF I/O] Transceiver's reference
signal status setting.
IN, OFF, OUT
REF Adjust Internal reference signal
frequency adjustment.
0~100% (in 1% steps)
ACC SET(Continued)
SET [F-7]
ACC [F-2]
To Next Page
Loading...
