Icom IC-7851 - Select Memory Scan

12-7
12
SCANS

Memory scan
 The Multi-function screens are OFF.
Push [V/M]. q
• Selects the Memory mode.
• Pushing [V/M] toggles between the VFO and Memory
modes.
Push [SCAN](F). w
• The Scan screen is displayed.
Push [MEMO](F). e
• The Memory scan starts.
• “
MEMORY SCAN
” and decimal points blink while scan-
ning.
• Push [MEMO](F) to cancel the scan.
• Rotating [MAIN DIAL] also cancels the scan.
When the scan detects a signal, the scan stops, r
pauses or ignores it, depending on the Scan Re-
sume setting and the squelch status.
Two or more memory channels must be programmed
for the Memory scan to start.
[MAIN DIAL]
[V/M]
[EXIT/SET]
(F) Function keys
• While scanning
• While scanning
BlinksBlinks
BlinksBlinks
 The Multi-function screens are OFF.
Push [V/M]. q
• Selects the Memory mode.
• Pushing [V/M] toggles between the VFO and Memory
modes.
Push [SCAN](F). w
• The Scan screen is displayed.
Push [SEL No.](F) several times to select the Select e
scan number from “1,” “2,” “3,” or “1,2,3.”
Push [MEMO](F). r
• The Memory scan starts.
• “
MEMORY SCAN
” and decimal points blink while scan-
ning.
Push [SELECT](F). t
• The Select memory scan starts.
• “
SELECT MEMORY SCAN
” blinks.
• Push [SELECT](F) again to return to the Memory scan.
• Push [MEMO](F) to cancel the scan.
• Rotating [MAIN DIAL] also cancels the scan.
When the scan detects a signal, the scan stops, y
pauses or ignores it depending on the Scan Re-
sume setting and the squelch status.
Two or more memory channels must be designated
as select memory channels, as well as the same
Select scan number, for the Select memory scan to
start.

Select memory scan