15-19
15
SET MODE
Others set screen (continued)
USB Keying (CW) (Default: OFF)
You can control to transmit, receive and keying from
the PC, through the USB port.
Select the control port to be used for communication
between the IC-7851 and PC, according to the operat-
ing condition.
• OFF: Turn OFF the function.
• USB1 DTR: Use the DTR terminal on the CI-V
(PC) side.
• USB1 RTS: Use the RTS terminal on the CI-V
(PC) side.
• USB2 DTR: Use the DTR terminal on the DECODE
(IC-7851) side.
• USB2 RTS: Use the RTS terminal on the DECODE
(IC-7851) side.
You cannot select the terminal which is already se-
lected in the [USB SEND] item or [USB Keying
(RTTY)].
USB Keying (RTTY) (Default: OFF)
You can control to transmit, receive and RTTY (FSK)
from the PC, through the USB port.
Select the control port to be used for communication
between the IC-7851 and PC, according to the operat-
ing condition.
• OFF: Turn OFF the function.
• USB1 DTR: Use the DTR terminal on the CI-V
side.
• USB1 RTS: Use the RTS terminal on the CI-V
side.
• USB2 DTR: Use the DTR terminal on the DECODE
side.
• USB2 RTS: Use the RTS terminal on the DECODE
side.
You cannot select the terminal which is already se-
lected in the [USB SEND] item or [USB Keying
(CW)].
Keyboard Type (Default: Japanese)
Selects the connected keyboard type.
• Options: English, Japanese, United Kingdom, French,
French(Canadian), German, Portuguese,
Portuguese (Brazilian), Spanish, Spanish
(Latin American), Italian
Keyboard Repeat Delay (Default: 250ms)
Sets the repeat delay time of the keyboard.
• Options: 100 ms–1000 ms (in 50 ms steps)
Keyboard Repeat Rate (Default: 10.9cps)
Sets the repeat rate of the keyboard.
• Range: 2.0cps–30.0cps
Mouse Pointer Speed (Default: MID)
Selects the mouse pointer speed.
• Options: SLOW, MID, FAST
Mouse Pointer Acceleration (Default: ON)
Turns the mouse pointer acceleration ON or OFF.
• OFF: Turn OFF the function.
• ON: Turn ON the function.
DHCP (Valid after Reboot) (Default: ON)
Turns the DHCP function ON or OFF.
• OFF: Uses the static IP address.
• ON: Uses the DHCP function.
If a DHCP server is in your network envi-
ronment, the IP address is automatically
obtained.
This setting takes effect after reboot.
IP Address (Valid after Reboot)
(Default: 192.168. 0. 10)
Sets the static IP address.
Push [t u](F) to select the item, and then turn
[MAIN DIAL] to set the address.
This setting is valid when "OFF" is selected the
[DHCP (Valid after Reboot)] item.
This setting takes effect after reboot.
Subnet Mask (Valid after Reboot)
(Default: 255.255.255.0 (24bit))
Sets the subnet mask to connect to your PC or LAN
(Local Area Network), through the Ethernet.
Push [t u](F) to select the item, and then turn
[MAIN DIAL] to set the address.
This setting is valid when "OFF" is selected the
[DHCP (Valid after Reboot)] item.
This setting takes effect after reboot.
To Next Page
Loading...
