Icom IC-7851 - Page 261

18-13
18
CONTROL COMMAND
• Memory content setting
Command : 1A 00
X
er−io, !0 !1 !2−!4 !5−!7
XXX ... ...XXXXXXXXXXXXXXXXXXXXXX XXXX XX
q, w!8−@7
q, w Memory channel numbers
0001–0099: Memory channel 1 to 99
0100: Programmed scan edge P1
0101: Programmed scan edge P2
To clear the memory channel contents, add the
code “FF” after the memory channel number.
(instead of the data e to @7)
This completes the memory clearing.
e Select memory setting
00 : OFF
01 : 1
02 : 2
03 : 3
r~i Operating frequency setting
See “• Operating frequency.”
o, !0 Operating mode setting
See “• Operating mode.”
!1 Data mode and tone type settings
XX
!1
0: OFF, 1: TONE, 2: TSQL
0: OFF, 1: DATA 1, 2: DATA 2, 3: DATA 3
!2~!4 Repeater tone frequency setting
!5~!7 Tone squelch frequency setting
See “• Repeater tone/tone squelch settings.”
!8~@7 Memory name settings
Up to 10 characters.
See “• Codes for the memory name, opening message,
NTP server address, CLOCK2 name, network name,
and network radio name contents.”
• Main or Sub band's frequency settings
Command : 25
X X X X X X X X X X 0 0
00: MAIN
01: SUB
Operating frequency data
(See p. 18-10)
• Main or Sub band's operating mode and filter
settings
Command : 26
Both data and filter settings can be skipped. In that
case, “DATA OFF” and the default filter setting of the
operating mode is automatically selected.
X X X X X XX X
Operating mode setting
(see p. 18-10)
Filter setting
(see p. 18-10)
Data mode setting
(see p. 18-11)
00: MAIN
01: SUB