iii
R DANGER HIGH RF VOLTAGE! NEVER touch an
antenna or antenna connector while transmitting. This
could cause an electrical shock or burn.
R WARNING! NEVER operate the transceiver during a
lightning storm. It may result in an electric shock, cause
power source and antenna before a storm.
R WARNING! NEVER connect the transceiver to an
an electric shock.
R WARNING! NEVER mount the transceiver’s
main unit overhead. The weight of the main unit is
approximately 8.6 kg, and it could easily fall due to
wave shocks or vibration. The unit must be mounted
R WARNING! NEVER connect a power source
of more than 12 V or 24 V DC (depending on the
transceiver version). This connection could cause a
R WARNING! NEVER place the transceiver where
normal operation of the vessel may be hindered or
where it could cause bodily injury.
R WARNING! NEVER let metal, wire, or other objects
contact the transceiver inside or make incorrect
contact with connectors on the front panel. This could
cause an electric shock or damage the transceiver.
CAUTION DO NOT reverse the DC power cable
polarity. This could damage the transceiver.
CAUTION: DO NOT use harsh solvents such as
could damage the equipment surfaces. If the surface
becomes dusty or dirty, wipe it clean with a soft, dry
cloth.
CAUTION: DO NOT use or leave the transceiver
the dashboard.
CAUTION: DO NOT use or leave the transceiver in
excessively dusty environments.
CAUTION: DO NOT
assignments and may damage the transceiver.
NEVER place the transceiver in an insecure place to
BE CAREFUL! The transceiver’s main unit may
become hot after continuously transmitting for long
periods of time.
BE CAREFUL! The remote controller’s front panel
meets IPX7 requirements for waterproof protection.
However, once the remote controller has been
dropped and cracked, or the waterproof seal is
cracked or damaged, waterproof protection cannot be
guaranteed.
L The connectors on the rear panel do not meet IPX7.
NOTE: Install the transceiver and microphone at
a distance of more than 1 meter from the vessel’s
magnetic navigation compass.
The LCD display may have cosmetic imperfections
that appear as small dark or light spots. This is not a
malfunction or defect, but a normal characteristic of
LCD displays.
PRECAUTIONS
Icom is not responsible for the destruction, damage
to, or performance of any Icom or Non-Icom
equipment, if the malfunction is because of:
•
natural disasters, disturbances, riots, war, or
radioactive contamination.
• The use of Icom transceivers with any equipment
that is not manufactured or approved by Icom.
Icom, Icom Inc. and the Icom logo are registered
trademarks of Icom Incorporated (Japan) in Japan,
the United States, the United Kingdom, Germany,
France, Spain, Russia, Australia, New Zealand, and/or
other countries.
NMEA 2000 is a trademark of the National Maritime
Electronics Association, Inc.
All other products or brands are registered trademarks
or trademarks of their respective holders.
To Next Page
Loading...
