Wash Configuration Tunnel Master
Jr. User Manual—Version 3.0
50 January 2016
Wet Down Period Enter the number of seconds you would like to have the wash equipmen t
turned on for the wet down process. A wet down will fire all of the outputs that
have Y for the wet down option.
Flash On In 100 mili-seconds increments how long the relay will flash on.
This is what the system looks at when you set the output flash to Y.
Flash Off In 100 mili-seconds increments how long the relay will flash off. This is what the
system looks at when you set the output flash to Y.
Shift This displays the shift number that the system is currently on.You cannot change
this setting.
Auto Shift Enter Y for yes, N for no. If you set this option to Y, the system will automatically
close the shift at midnight. This option should be set to Y if you are using the
Tunnel Master
Jr. Interface.
Tax Rate 1.0% The percentage rate for the first tax rate charge.
Tax Rate 2.0% The percentage rate for the second tax rate charge.
Stacking Enter Y for yes or N for no. If you set this option to Y, the system will start
stacking. This option should be set to N if using the Tunnel Master
Jr. Interface .
Input Device This is set K for keypad, P for push button or C for Computer / Controller. This is
used to interface with Tunnel Master® Sr.
Push Button Rows If a push button entry station is being used, enter the number of rows, going
across, of buttons on the station. This will tell the system what inputs to accept. If
you do not have a push button station, this option is disregarded.
Push Button Cols If a push button entry station is being used, enter the number of columns ,
going down, of buttons on the station. If you do not have a push button station,
this option is disregarded.
Console Debug This is a debug utility that ICS may use to track system activity.
This should be set to N if you are using the Tunnel Master
Jr. Interface.
Header 1 Enter information desired to display on the first line on the top of reports and
receipts. This is usually company information.
Header 2 Enter information desired to display on the second line on the top of reports
and receipts. This is usually company information.
Header 3 Enter information desired to display on the third line on the top of reports and
receipts. This is usually company information.
Header 4 Enter information desired to display on the fourth line on the top of reports and
receipts. This is usually company information.
Footer 1 Enter information desired to display on the first line on the bottom of receipts.
This is usually a message to the customer.
Footer 2 Enter information desired to display on the second line on the bottom of
receipts. This is usually a message to the customer.
Table 9: Wash Settings Menu
Wash Setting Field Description
To Next Page
Loading...
Need help?
General