Entrance Keypad Tunnel Master
Jr. User Manual—Version 3.0
72 January 2016
SHIFT BREAK
There are two ways to break (close) a shift. The first is to go into Wash
Settings and select Yes for the Auto Shift menu option. This option will
automatically close the shift at midnight each night. The second option is to
go to the main
display menu and select Shift Break. This option allows the
user to close a shift manually at a time selected by the user. This option
would be used by operators that wish to balance their shifts at the end of the
day
instead of waiting until
the next morning.
It is very important that one of the two options be used each day. Failure to
close a shift will result in car and service counts being inaccurate, as they
would run multiple days into one shift. You
may also close your shift by
pressing the up arrow on the entrance keypad.
WARNING: PRESSING UP ARROW KEY ON ENTRANCE KEYPAD WILL
RESET YOUR CURRENT CAR COUNT!
3 Press the ENT button on the display keypad to
advance to additional services.
EXTERIOR W 0052 05- POLISH WAX 0023
SILVER WAS 0023 06-CLEAR COAT 0015
GOLD WASH 0015 07-[EMPTY]0000
PLATNUM W 0009 08-[EMPTY]0000
4 Repeat Step 3 to review up to
32 possible services.
NOTE: Any service number skipped in the
service setup will display as EMPTY.
5 Press the MENU button on the display pad to
return to the Main Menu.
[1] Shift Break [4] View Counts
[2] Wet Down Wash [5] Print Reports
[3] Configure Wash
Table 20: View Service Counts Instructions
Step Action Screen Display
To Next Page
Loading...
Need help?
General