ICS Tunnel Master Jr User Manual

System Hardware and Installation Tunnel Master

Jr. User Manual—Version 3.0
14 January 2016
RESETTING DEFAULT CONFIGURATION SETTINGS
The Tunnel Master

Jr. is delivered with pre-loaded settings. You can erase
these settings before configuring your own settings. The following procedure
shows how to erase the current settings.
NOTE: ICS recommends a complete, first-time erase using DIP switch 6, as
described below.
To erase all configuration settings, follow these steps:
1 Remove the battery from the Main CPU PCB.
2 On the main CPU board, set DIP switch 6 to the ON position.
3 On the main CP
U board, press and hold the reset switch (SW1) for about
30 seconds, and then release the reset button.
Wait for the display to come back up. All settings are erased.
4 Put the battery back into its socket.
5 On the main CPU board, return or set the DIP
switch 6 to the OFF position.
The Tunnel Master

Jr.is ready to begin your configuration process.
 See “DIP Switch Settings” on page 40.
Rules for Installation
Before you begin, please read this entire manual.
 Install permanent connections in accordance with local building/fire
codes, all Federal, State, and Local codes.
 All wiring must meet the National Electrical Code ANSI/NFPA 70.
 Canadian users must also comply with the Canadian Electrical Code CEC,
CAN/CSA C22.1 Pt. 1.
 High-voltage (AC) and low-voltage (DC) must not be combined in a
common conduit, junction box, or wire trough.
 Power for
the Tunnel Master

Jr. and any peripherals must come from the
dedicated UPS, as supplied by ICS.
 The Tunnel Master

Jr. and peripheral equipment must be properly
grounded.
 Test connections in the manual override position prior to system start-up.
 Check through packing materials for manuals, cables, connectors, etc.
before disposing of cartons.

ICS Tunnel Master Jr Specifications

General

Brand	ICS
Model	Tunnel Master Jr
Category	Controller
Language	English