Part 1 - Getting Started
27
Advanced Settings
In PTZ mode, selecting a camera and then clicking Menu
button loads the Advanced PTZ screen as shown below.
You can load the Advanced PTZ screen also by pressing
the Play/Pause button and then SETUP button on the
front panel. This menu lists Speed, Auto Pan, and other
advanced PTZ camera control options available for the
camera. Also selecting Point Move button moves PTZ
camera to the point that the user clicks. Options that
are not available for the selected PTZ camera remain
inactive.
You can use the mouse to control PTZ cameras. Left-
click on the mouse and drag to move the camera in the
desired direction and use the mouse wheel to zoom
in/out.
While in PTZ mode, place the mouse pointer close to
the bottom edge of the screen to display the PTZ Tools
window.
PTZ Camera Pan and Tilt
Zoom In/Out
Focus Near / Far
IRIS Open / Close
One Push
Set / Move to Preset
Device Menu supported
by the camera
•
The exact PTZ protocol supported by the camera
must be specied in order to use the NVR's PTZ
controls.
•
Drag and drop to reposition the PTZ Tools window.
•
Select the
icon to hide the PTZ Tools window.
To Next Page
Loading...
