Idis DR-6532P - Page 70

Part 2 - Conguration
70
– Select: Conrm the block selection in the selection
window.
– Clear: Clear the block selection in the selection
window.
– Reverse: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
– Select All: Select all blocks.
– Clear All: Clear all block selections.
– Reverse All: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
– Trip Direction: Dene in which direction the
motion has to occur in order for it to be considered
an event. Select In for movements from outside the
selection area in or Out for movements from inside
the selection area out.
– OK: Save the changes and exit the menu.
– Cancel: Exit the menu without saving the changes.
● Setup
– Sensitivity: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
– Ignoring Interval: The system does not produce
event log entries or remote notications for
events detected within a certain period of time
after Tripzone events of the camera channels are
detected. Set a value between 1 sec and 5 secs or
choose Never.
Trip Zone Ignoring Time does not aect Trip Zone
recording.
– Daytime Setup: Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specied range will
be assumed as nighttime by the system.
● Condition: When a specic event occurs, you can set
the condition that determines whether to operate
motion according to the status of other events.
– Reference Only: Set the event to be the subject of
a reference.
– Event: Set the reference event.
– Channel: Set the reference channel.
● Actions: Specify which actions to take when Trip Zone
is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Congure to be notied of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specic preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.