119
Configure System Settings
Save successful transactions
If this value is set then in stead of only the corrupted 'translated' XML files, all 'translated' XML files will be stored. Only used
for troubleshooting purposes.
Store PayCon 2 transaction XML
The raw PayCon 2 transaction XML files will be saved. Only used for troubleshooting purposes.
Confirm cost center selection
When enabled the Cost Centre selection must be confirmed.
Create new cards
When presenting an Inepro card that is not yet known in the system it's possible to:
1. Create this as a new card without a warning.
2. Create this as a new card and send a warning.
3. Create this as a new card, block it and send a warning. (The card cannot be used in the system until it is unblocked by
the administrator).
Retry failed transactions at
Set a time at which the failed transaction are retried. 'Auto retry failed transactions' must be enabled.
ScanToX server address
The IP address where the ScanToX service is running.
ScanToX service enabled
Will the scanToX service be used?
Subscription Printer
<Obsolete>
Update unassigned PayCon's
Update the price mutations, Red lists, etcetera to all the PayCon's also those unassigned in the terminal menu.
Normally to would needlessly overburden the system, so this setting is disabled by default.
To Next Page