Antenna Firmware Upgrade procedures:
1. Click on “Browse” button to select the upgrade package le that you wish to upgrade. Click on the “Start Upload”
button to transfer the Firmware package le (“*.fwp”) to iARM module. Wait until the page is loaded.
1
2
2. After the package le is transferred, it’ll show “upgrade from vx.xx Version to vx.xx Version”. Enable the checkbox to
select the rmware le that you wish to upgrade.
3. Click on “Start Update” button.
2
1
4. During the upgrade process, the window will display process status.
5. If the rmware is successfully upgraded, it will display “The rmware update is completed.”
6. Click on "Back to main page" to go out of the screen.
To verify the upgraded rmware version, go to Dash Board > Software Information.
1
2
NOTE: To roll back to the previous rmware package version or latest package version,
select Rollback Upgrade menu on the Antenna Firmware Upgrade page.
To Next Page
Loading...
Need help?
General
