Intellian GX60 - Connecting Cables (Customer Supplied)

GX60 – Marine Satellite Communication System
38
Power Cable
RF Cable(Rx)
RF Cable(Tx)
Radome Bottom View
AC Power
100-240 V ~ 50/60 Hz 3A
Tx Rx
Connecting Cables (Customer Supplied)
Ensure that the power switch of antenna is off during the installation period.
Connect the two(2) RF cables to the antenna RF connectors and Power cable to the antenna power connector.
Rx
Tx
Rx
Tx
“Rx” RF cable
Power cable
“Tx” RF cable
1. RF cables are labeled Tx and Rx for easy installation. Connect the “Tx” RF cable to the Tx connector and the “Rx”
RF cable to the Rx connector as shown in the gure below. Ensure all cables are rmly fastened to the connectors.
After connecting, slide the heat shrink sleeve onto the connector body and cable jacket then heat it to
compress it into place using a hot air gun. Alternatively, use self-amalgamating tape and UV protective
electrical tape.
2. Connect the Power cable to the power connector.
CAUTION: Please ensure that the Tx and Rx cables are correctly connected to the
each Tx/Rx connector on the antenna. Failure to connect the cables to the correct
connector on the antenna will cause system damage.