Introduction
With embedded Remote Access (Aptus Web) function, the v-Series can be monitored, controlled, and diagnosed
remotely from anywhere, anytime through the TCP/IP protocol. This not only can save time but also saves the cost
generated from the hundreds of routine maintenance activities, such as operating rmware upgrades, tracking
parameters resets, and system diagnostic.
How to access Aptus Web:
1. Connect an Ethernet Cable between your PC and the Management Ethernet Port.
2. Enter the BDT's IP address (192.168.1.2) into your web browser's address bar to login into the BDT’s internal
HTML page, if this system has not been changed from the BDT’s factory default.
NOTE: Aptus Web can be displayed in Internet Explorer 7 or later and is also compatible
with Firefox and Chrome web browser.
Using Aptus Web
To Next Page
Loading...
Need help?
General
