Intellian GX60 - Page 93

93
Using Aptus Web
3
Current Antenna
Position / Target
Antenna Position
Displays current antenna position.
- Relative Azimuth: displays antenna relative AZ angle.
- Absolute Azimuth: displays antenna absolute AZ angle.
- Elevation: displays antenna elevation angle.
4
GPS
Displays current GPS information.
- Longitude (East / West)
- Latitude (North / South)
5
Heading
Device
Displays current Heading Device: NONE, NMEA, NMEA 2000, GROUND TEST. If the ship's
gyrocompass input is other than NMEA separate purchase of NMEA Converter is required.
- Heading: displays ship's heading information.
6
BOW Offset Display current bow offset.
7
DVB Information
Displays DVB tracking mode's current tracking information.
- Frequency: displays tracking frequency.
- Symbol rate: displays symbol rate.
- NID: displays network ID.
- Verify type: displays verication type(AGC, DVB, DVB Decode).
8
NBD Information
Displays NBD tracking mode's current tracking information.
- IF Frequency: displays tracking IF frequency.
- Bandwidth: displays detection bandwidth.
- Base Local: displays base local frequency.
9
Local Frequency
Setting (MHz)
Displays current LNB's local frequency and voltage.
10
Software
Information
Displays current Antenna and BDT rmware versions and Satellite Library version installed in the
system.
- Antenna Stabilizer Version: displays the antenna stabilizer version.
- Antenna PCU Version: displays the antenna PCU version.
- ACU(BDT) Main Version: displays the ACU(BDT) Main version.
- Library Version: displays the Library version.
11
Azimuth
Animation
Shows a graphical representation of the current antenna position to identify whether or not the
antenna is aligned properly to the target satellite or is in a block zone.
12
TX Enable
Displays whether or not the antenna is able to transmit the data. The TX function will only be enabled
(shows BLUE dot ) only if all of the factors listed below shows "BLUE" dot.
- Enable Mode: antenna is not in SETUP mode.
- Blockage: antenna is not facing the predened block zone(s).
- Pointing: antenna is pointing to the target satellite.
- Modem Lock: satellite modem is sending a logic input to the
BDT to identify when the antenna tracks on the correct satellite.
- LNB Rotate: LNB is not rotating.
13
Tracking
Satellite
Displays current tracking mode.
- Satellite Name: displays satellite name.
- Longitude: displays satellite orbit position.
- Skew Offset: displays Skew offset.
- Tracking Method: displays current tracking mode (DVB/ NBD).
- RX Polarization: displays current RX polarization.
- TX Polarization displays current TX polarization.
14
Antenna
Information
Displays the antenna product information.
- Antenna Size: displays the antenna size.
- Antenna Product: displays the antenna product name.
- ACU Product: displays the ACU product name.
- Antenna Serial Number: displays the antenna serial number.
- ACU Serial Number: displays the ACU serial number.
- System Polarization: displays the system polarization.
- System Band: displays the system band.
15
SCM
Information
Displays the Modem information.
- Provisioning Key: displays the provisioning key number.
- Terminal Type: displays the terminal type number.