Chapter 3 — Configuring the Computer
92 CK60 Handheld Computer with Windows Mobile User’s Manual
Configuring CK60 Parameters
You can configure many parameters on the CK60, such as the bar code
symbologies it decodes or the network settings. These characteristics are
controlled by configuration parameters. The values you set for these
configuration parameters determine how the computer operates. Use
configuration commands to configure the CK60.
Configuring with the Setup Assistant
When first setting up the CK60, use the Setup Assistant to set or enable
basic network parameters and connect your CK60 to the network.
The Setup Assistant guides you through setting the following basic network
parameters: date and time (including time zone), SSID (Network name),
DHCP server or IP address, subnet mask, and default router, primary and
secondary DNS or WINS addresses, and device name.
To set other parameters, use another configuration method. The Setup
Assistant runs on the CK60 when you turn on the computer.
After the Setup Assistant is complete, the CK60 should communicate with
the network. A network connection icon appears in the taskbar.
Configuring the Computer With Intermec Settings
Use the Intermec Settings applet to configure the CK60 and view system
information. You can access the Intermec Settings applet while running any
application.
To access the Intermec Settings applet
For detailed information on most of the commands available in the
Intermec Settings applet, see the Intermec Computer Command Reference
Manual (P/N 073529) via the Intermec web site. Go to “Global Services
and Support” on page xi for access information.
• From the CK60 desktop, select Start > Settings > the System tab > the
Intermec Settings icon.
To Next Page
Loading...
