Chapter 3 — Configuring the Computer
100 CK60 Handheld Computer with Windows Mobile User’s Manual
3 Enter the Bluetooth address assigned to your CK60 (shown in your
Bluetooth applet), then click OK to close this dialog.
4 The connection label for the SF51 appears to the right, similar to the
following. Scan the label once, then confirm the blue Intermec Ready-
To-Work™ indicator on the end of the SF51 starts blinking, which
means it is trying to connect. When connected, the indicator assumes a
steady blue, then SF51 data gets wedged through the keyboard interface.
Viewing SF51 Information from Your Computer
Note that in the CK60, the Intermec Settings applet can display up to
seven separate SF51 connections. The following illustration shows such
connections under the Data Collection option.
To view the SF51 connections
1 Tap (+) to expand Data Collection.
2 Tap (+) to expand the SF51 Scanner connections to view MAC
addresses, firmware version numbers, and whether each scanner is
connected to the CK60.
3 When you clear (uncheck) Enable scanner port, the SF51 is
disconnected from the CK60.
To Next Page
Loading...
