Chapter 1 — Using the Computer
CK60 Mobile Computer with Windows Mobile User’s Manual 23
To set your CK60 to vibrate
Setting the Vibrate Mode Using Intermec Settings
You can also set the vibrate using the Intermec Settings applet.
To set your CK60 to vibrate
1 Tap the Volume icon at the top of the screen.
2 Select Vibrate.
3 Tap anywhere onscreen to clear the control from your display.
1 Tap Start > Settings > the System tab > the Intermec Settings icon.
2 Tap (+) to expand Device Settings > Good Read > any of the Scanner
options > Beep or Vibrate, then tap Vibrate.
3 To disable the vibrate, tap any of the other Beep options.
4 Select File > Save Settings to save your changes.
5 Select File > Exit to close the applet.
To Next Page
Loading...
