Chapter 5 — Network Support
142 CK60 Mobile Computer with Windows Mobile User’s Manual
Choosing Between Microsoft and Funk Security
Before you can implement a security solution on the CK60, you need to
choose between Microsoft and Funk security:
• By default, Funk security is enabled. It provides everything you get with
Microsoft security plus the addition of Cisco Compatible Extensions
features. It also provides additional authentication types like EAP-TTLS,
LEAP, and EAP-FAST.
• Microsoft security, with its Microsoft Zero Config feature, is also
available. To switch to Microsoft security, go to “Configuring Microsoft
Security” on page 159 to start.
Configuring Funk Security
You can define up to four profiles for your Funk Odyssey security.
Different profiles let your CK60 communicate in different networks
without having to change all of your security settings. For example, you can
set up one profile for the manufacturing floor and one for the warehouse.
To enable Funk Security
Using WPA Security
Wi-Fi Protected Access (WPA) is a strongly enhanced, interoperable Wi-Fi
security that addresses many of the vulnerabilities of Wired Equivalent
Privacy (WEP). Instead of WEP, WPA uses Temporal Key Integrity
Protocol (TKIP) for its data encryption method. Currently, WPA satisfies
IEEE 802.11i standards.
Note: Your security choice does not depend on your authentication server.
For example, you can choose Funk security if you use Microsoft Active
Directory® to issue certificates.
1 Select Start > Settings > the System tab > the Intermec Settings icon.
2 Tap (+) to expand Communications > 802.11 Radio > Funk Security.
3 Select an active profile, then configure its security settings.
To Next Page
Loading...
