Chapter 1 — Using the Computer
CK60 Mobile Computer with Windows Mobile User’s Manual 19
Using the Secure Digital Card
Use a Delkin Devices Secure Digital card to increase file storage and install
software. Its card slot is on the top of the CK60 just above the scanner
window. Do the following to insert a card in the CK60:
1 Press the power switch to turn off the CK60, remove the two screws on
the Secure Digital card slot door and remove the door (see the following
illustration). Be sure to torque the screws to this door to 1.5 in-lbs.
2 Gently insert the Secure Digital card into the CK60 with the printed
side facing the keypad and screen side of the CK60.
3 Push the card into the slot until it latches in place and the steel card
retainer covers the end of the Secure Digital card.
4 (Optional) Replace the door, insert the door catch into the slot above the
steel card retainer, replace the two screws, then press the power switch to
turn on the CK60.
5 To remove the card, push in on the Secure Digital card until you hear it
unlatch. The card should eject far enough that you can easily remove it
from the CK60. If the card does not eject easily, turn the door upside
down, then use the catch to pull out the Secure Digital card.
Using Software Tools
The following Intermec software tools are available as free downloads:
SmartSystems Foundation Console (www.intermec.com/SmartSystems)
This tool includes a management console that provides a default method to
configure and manage Intermec devices “out-of-the-box,” without the
purchase of additional software licenses. This is for anyone who must
configure and deploy multiple devices or manage multiple licenses.
Note: MultiMediaCards (MMCs) and CompactFlash (CF) storage cards
are not supported in the CK60.
You can corrupt your Secure Digital card if you do not follow these
installation and removal procedures exactly. Before installing a Secure
Digital card, inspect the gasket on the door for any damage or wear,
and replace the door if any damage or wear is found
Screw
Screw