Why is a large part of the dot line missing on my Intermec EasyCoder 501 E Label Maker printouts?
If a large part of a dot line is missing on printouts from your Intermec Label Maker, it could be due to a wrong X-start or Width parameter; change the parameter. Alternatively, it might be a failing printhead, which would need to be replaced, or a failing strobe signal, requiring a check of the CPU-board.
Why is the printout missing along the inner edge on my Intermec EasyCoder 501 E?
If the printout is missing along the inner edge when using your Intermec Label Maker, it could be caused by bad media alignment; adjust it. Alternatively, the X-start parameter value might be too low; increase it.
Why is the last part of the print image missing on my Intermec Label Maker?
If the last part of the print image is missing when using your Intermec Label Maker, it is likely due to a too small image buffer. Increase the buffer size to resolve this issue.
Why is there no thermal transfer printout from my Intermec EasyCoder 501 E Label Maker?
If you're getting no thermal transfer printout from your Intermec Label Maker, ensure that the ink-coated side of the ribbon faces the media. If not, reload the ribbon correctly.
General| Print Method | Direct Thermal |
|---|---|
| Print Resolution | 203 dpi |
| Maximum Print Width | 4.1 inches |
| Media Width | 4.5 inches |
| Memory | 4 MB Flash |
| Connectivity | USB, Serial |
| Display | LCD |
| Supported Barcode Types | Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, Interleaved 2 of 5, Codabar, POSTNET, PDF417, Data Matrix |
| Weight | 4.4 lbs |
| Power Supply | 100-240V AC, 50-60Hz |
To Next Page
