Intermec EasyCoder PF4i - Data Dump; Memory Reset; Media

Chapter 5 — Setting Up the Printer
EasyCoder PF4i User’s Guide (IPL Version) 55
Format Label
The Format Label contains a single format that you can use to
evaluate the print quality of a particular format. This option
prints labels for all the formats stored in the printer’s memory.
Page Label
The Page Label tests the ability of the printer to receive and print
single or multiple pages of label data that is sent from the host.
This option prints labels for all the pages stored in the printer’s
memory.
UDC Label
The UDC Label tests the ability of the printer to receive and
print single or multiple user-defined characters (bitmap graphics)
that are sent from the host. This option prints labels for all the
UDCs stored in the printer’s memory.
Font Label
The Font Label contains all the characters in a single font. This
option prints labels for all the user-defined fonts (UDF) stored in
the printer’s memory.
Data Dump
If data dump is enabled by selecting the “Yes” option, the printer
prints all data and protocol characters received on the serial port.
An ASCII and hexadecimal representation of each character is
printed.
Memory Reset
There are two options. The memory will be reset to factory
default as soon as an option has been selected and <Enter> is
pressed. Select between “All”, which resets the entire memory,
and “Configuration”, which just resets the configuration part of
the memory.
Media
The media parameters tell the firmware the characteristics of the
media that will be used so that the printout will be positioned
correctly for the best possible quality.