Chapter 5 — Setting Up the Printer
58 EasyCoder PF4i User’s Guide (IPL Version)
Cutter (optional)
By default, “Not Installed” is displayed. If a cutter is installed,
you must manually indicate that condition to the firmware by
selecting either “Enable” or “Disable.” Once you have done that,
you can also use IPL commands to enable or disable the cutter:
<STX>R<ETX> enter print/configuration mode
<STX>c0<ETX> Disable cutter
<STX>c1<ETX> Enable cutter
Label Taken Sensor (optional)
To make the printer work in self-strip mode, which means it
waits for a label to be removed before the next label is printed, the
self-strip mode must be enabled. This can also be done by
executing the following commands:
<STX>R<ETX> enter print/configuration mode
<STX><SI>t0<ETX>Disable self-strip
<STX><SI>t1<ETX> Enable self-strip
If the label taken sensor does not work properly, the sensitivity
can be calibrated using Setup Mode. Select “LTS Calibration”
and follow the instructions in the display. Make sure that no
direct sunlight or interior lighting interferes with the label taken
sensor.
Returning to Factory Default Setup
There are three ways to return to the factory default setup of the
printer:
• Insert a special CompactFlash memory card and restart the
printer.
• Use the Memory Reset option in the Test/Service part of the
Setup Mode.
• Use the printer’s built-in keyboard.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
