Intermec EasyCoder PF4i User Manual

Chapter 7 — Options
70 EasyCoder PF4i User’s Guide (IPL Version)
Integral Liner Takeup Kit
The integral liner takeup unit is an optional device for peel-off
(self-strip) operation, which means the labels are separated from a
liner (backing paper) after printing and the liner is wound up on
an internal hub. The unit also includes a guide shaft. Peel-off
operation cannot be combined with Quick-Load guides.
This is a factory-installed option only and is used to separate
labels from the liner and wind up the spent liner inside the
printer’s media compartment. Labels, tickets, tags, etc. can be
wound up inside the media compartment after printing by fitting
a special guide to the front of the print unit.
The kit consists of a stepper motor that drives the liner drive
roller in the print unit (fitted as standard) and a takeup hub in
the media compartment. A guide shaft is fitted to the center
section immediately behind the slack absorber. A guide plate is
fitted at the rear of the media compartment and can be used to
replace the standard tear bar on the print unit for batch takeup
operation.
Operation and media load are described in Chapter 3,“Media
Load” on page 17.
Media Supply Hub
The rotating media supply hub is designed to fit media roll cores
with an internal diameter of 38-40 mm (1.5 inch). The hub can
be fitted in the same positions as the supply roll post, see Chapter
2. Being factory installed, the position of the media supply hub is
not intended to be changed by the operator.
3-inch Adapter
The 3-inch/76 mm adapter is included in the package and makes
it possible to use media rolls with 3 inch/76 mm inner diameter
cardboard cores.
Note: The cutter must be enabled during Configuration in Setup
Mode. For more information, see “Cutter” on page 50 and
“Paper Cutter” on page 69.

Intermec EasyCoder PF4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power consumption (standby)	15 W
Power consumption (printing)	300 W
Media thickness	3/7.5 mm
Maximum label width	104 mm
Maximum label length	0.4 m
Maximum roll diameter	152.4 /213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Product color	Blue, Silver
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	405 mm
Width	244 mm
Height	178 mm
Weight	8000 g