7. Configuration modes and utilities
ScanPlus 1800 - Installation Manual
139
- Smart cable special software version ("B" for example) :
- screen display : *1800 SR 1.02B CPU 1.0 1A03SCB*
- EPROM / Smart cable beeps / flashes as above + extra short beeps at the end to indicate
special version (2 beeps for "B")
flash memory upgrade with RS-232 cable 0-364032-00
\41\4A\0F\31\60
- necessary for online upgrade of the ScanPlus
flash memory with RS-232 cable 0-364032-00 !
- do not send this command directly from
EasySet to the ScanPlus - you must read this
command as a configuration code (send to the
setup sheet and print out) !!!
- see section 1 "Using EasySet" for details on
how to connect up for flash memory upgrade
with RS-232 cable 0-364032-00
display data string mode
\46\4E\60
- displays data string and checksum values on a
terminal screen when you read configuration bar
codes (the EasySet "View - Data String"
command shows the data string but does not
show the checksum)
- you will need the checksum if you want to send
commands directly from the host terminal to the
ScanPlus 1800 in "slave mode" (see "predefined
terminal selections - RS-232 - special RS-232
configurations" in section 3, "Terminal / cash
register used in your application")
- hexadecimal values separated by backslashes or
other characters (depending on your terminal
emulation setup)
- remains active until you switch off the product
To Next Page
Loading...
Need help?
General
