InVid Tech Paramont PD Series - Buzzer; Push Message; Alarm Server

Alarm Management
DVR User Manual
80
www.invidtech.com
9.5.4 Buzzer
Click StartSettingsAlarmEvent NotificationBuzzer to go to the buzzer configuration
interface. Set the delay time of the buzzer and then click “Apply” to save the setting. You can
click “Test” to test the buzzer.
9.5.5 Push Message
Click StartSettingsAlarmEvent NotificationPush Message to go to the interface as
shown below. Check “Enable”, choose the push schedule and then click the “Apply” button to
save the settings. If Push Server is online, it will push messages to the mobile clients.
9.5.6 Alarm Server
Go to AlarmAlarm Server interface as shown below.
Enable the alarm server and enter server address and port of the alarm server. Then select
protocol. If “Send Heartbeat” is enabled, set the interval times. After that, test the effectiveness
of the alarm server. Having tested successfully, please click “Apply”. When an alarm occurs,