InVid Tech Paramont PD Series - Intrusion Detection

Alarm Management
DVR User Manual
75
www.invidtech.com
A->B: the alarm triggers when the intruder crosses over the alert line from A to B.
A<-B: the alarm triggers when the intruder crosses over the alert line from B to A.
④ Draw line. Refer to the interface as shown above. Check “Draw line” and then drag the
mouse in the image to draw an alert line. Uncheck the “Draw line” if you finish the drawing.
Click the “Clear” button to delete the alert line.
⑤ Click “Apply” to save the settings.
⑥ Click “Processing Mode” to go to the alarm handling configuration interface of line
crossing detection.
Line Crossing Alarm Handling Configuration:
① Click StartSettingsAlarmIntelligence AlarmLine Crossing to go to the following
interface.
② Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”,
“Pop-up Video” and “E-mail”. The alarm handling setting of line crossing alarm is similar to
that of the sensor alarm (see 9.1 Sensor Alarm
for details).
③ Click “Apply” to save the settings. You can click “Crossing Config” to go to the line
crossing configuration interface.
9.3.4 Intrusion Detection
Intrusion Configuration:
Alarms will be triggered if someone or something intrudes into the pre-defined area.
① Click StartSettingsCameraIntelligent DetectionIntrusion Detection to go to the
following interface.
② Select the camera, enable the intrusion detection and set the duration.