11
1.11 Unpacking Instructions
Note - If the packaging shows any signs of external damage, check unit for damages and notify the
shipping agent immediately.
CAUTION: To minimize the risk of damage to the device, IPG Photonics
recommends that you unpack your 2D Scanner using the following procedure.
1.11.1 Unpacking a Unit from the Shipping Carton
To unpack your unit from the shipping carton:
1. Place the package on a stable surface such as the floor or a large table.
2. Open the carton and remove the foam cover and store for later use.
3. Carefully lift the Scanner out of the box.
4. Carefully place contents on a stable surface.
5. Remove the lens cover from the 2D Scanner before use. Store for later use if needed.
6. Do not remove the cap that covers the fiber port until a fiber is ready to be immediately
installed. Remove the cap to install the fiber; it should be re-installed whenever the fiber is
removed.
a. A 44-pin Male Scan Head Control cable is included with your shipment. This cable
connects to the Scan Controller box for the Mid-Power and High-Power Scanners.
7. Retain all packaging for future transportation or storage needs.
To Next Page
Loading...