warning devices and training/safety procedures. In addition, it is important
to install the output assembly away from eye level.
The interaction between the laser and the material being processed can also
generate high intensity UV and visible radiation. Ensure that all laser
enclosures are in place to prevent eye and skin exposure to visible and
invisible collateral radiation.
WARNING: Ensure the device is properly grounded through a low impedance
functional earth conductor.
To ensure electrical safety:
1. Always use your device in conjunction with properly grounded power source.
2. Before supplying power to the product, make sure that the correct voltage of the DC power
source is used. Failure to use the correct voltage could cause damage to the product.
3. Before switching the power on, ensure the voltage corresponds to the specified level.
4. There are no operator serviceable parts inside. Do not attempt replacement of any parts. Refer
all servicing to qualified IPG personnel. Do not remove covers. Any tampering with the product
might void the warranty.
5. Connections to external circuits except for Mains connections: the external connections
between this product and other external devices are PELV (Protected Extra-Low Voltage) as
defined by IEC 61140. Non- Mains outputs of other devices connected to this product should
also be PELV or SELV (Safety Extra-Low Voltage).
6. Keep away from sources of shock or vibrations.
WARNING: The input voltage to the laser is potentially lethal. All electrical cables
and connections should be treated as if it were a harmful level. All parts of the
electrical cable, connector, or device housing should be considered dangerous.
1.8.4 Environmental Safety
WARNING: Ensure that all personal protective equipment (PPE) is suitable for the
output power and wavelength range listed on the laser safety labels that are affixed
to the laser.
CAUTION: Damage to the laser is possible, unless caution is employed in operating
the device.
Do not dispose of the product with domestic waste. Electronic devices have to be
disposed according to the regional directives on electronic and electric waste
disposal.
To Next Page
Loading...
