Chapter 4 IP Testing
Establishing a PPPoE session
HST-3000 Ethernet Testing User’s Guide
135
Terminating a
PPPoE session
After testing is complete, you must manually terminate the
PPPoE session.
To terminate a PPPoE session
– Press the Action soft key, and then select Log-Off.
PPPoE Timeout The HST is not physically
connected to a PPPoE
server, or it is configured to
use a service that is not
supported by the server.
– Verify that the HST is
physically connected to
the server.
– Verify that the service
name you specified is
correct, or, if a service
name is not required by
the server, set the Ser-
vice Name setting to No.
– Try to establish a new
session with the server.
Data Layer Stopped The physical Ethernet link
to the HST is lost.
Reconnect the physical
Ethernet link. The HST will
attempt to reconnect to the
server.
PPP LCP Failed There is a problem with the
server.
Try to establish a new ses-
sion with the server.
PPP IPCP Failed
PPPoE Failed
PPP Up Failed The PPPoE server dropped
a successful PPPoE ses-
sion.
Try to establish a new ses-
sion with the server.
Internal Error -
Restart PPPoE
The HST experiences an
internal error.
Try to establish a new ses-
sion with the server.
Table 11 PPPoE messages (Continued)
Message Typically Indicates: Resolution
To Next Page
Loading...
