JDS Uniphase HST-3000 - Launching an Application

Chapter 1 Getting Started
Configuring your test
28 HST-3000 Ethernet Testing User’s Guide
Launching an
application
Before powering on your unit and launching an application,
you must connect an Ethernet SIM to your base unit. For infor-
mation about connecting a SIM and powering the HST, see
the HST-3000 Base Unit User’s Guide.
The following procedure describes how to launch an applica-
tion.
To launch an application
1 Power on the HST-3000.
IPv6 OPTIC
1G and 100M optical
1G IPv6 Terminate – Layer 3 IP Traffic
– Layer 3 PING
– Layer 3 Traceroute
– Layer 4 Traffic
1G IPv6 Monitor / Thru – Layer 3 IP Traffic
100M IPv6 Terminate – Layer 3 IP Traffic
– Layer 3 PING
– Layer 3 Traceroute
– Layer 4 Traffic
100M IPv6 Monitor / Thru – Layer 3 IP Traffic
1. Available for 1G Optical tests only.
Table 9 Supported Applications, Test Modes, and Traffic (Continued)
Soft key / Circuit Application Test/Traffic