JDS Uniphase HST-3000 - Cable Status Results; Link Status Result

Appendix A Test Results
Cable Status results
262 HST-3000 Ethernet Testing User’s Guide
Cable Status results
The Cable Status category shows measurements associated
with running cable diagnostics on a link (see Figure 53).
After running the electrical Ethernet Cable test, if the link is
active, the type of cable your unit detected appears in the
Cable Status result category.
Link Status
result
After running the electrical Ethernet Cable test, the Link Status
test result indicates one of the following:
SFP Valid Indicates whether the SFP is recognized
by the HST as MSA compliant.
Undersized A count of frames under the minimum 64
byte frame length.
Table 15 Summary results (Continued)
Result Definition
Figure 53 Cable Status results display