Chapter 4 IP Testing
Configuring layer 3 IP tests
HST-3000 Ethernet Testing User’s Guide
143
Specifying IPv4
filter criteria
To specify IPv4 filter criteria
1 If you haven’t already done so, launch your application
(see “Launching an application” on page 28), and then
select a test (see the appropriate procedure below):
– “Selecting a layer 3 IP test” on page 120
– “Selecting a layer 4 TCP/UDP test” on page 165
2 Press the Configure navigation key.
A configuration menu appears.
3 Do the following:
a Use the left and right arrows to go to the IP Filter
menu.
Figure 30 IP Filter menu (IPv4 settings)
To Next Page
Loading...
