Chapter 1 Getting Started
Configuring your test
HST-3000 Ethernet Testing User’s Guide
35
Specifying
basic test
settings
After you launch an application, you verify and specify test
settings using the configuration menus. The following proce-
dure describes how to access the test configuration menus
and specify basic settings.
To specify basic test settings
1 Launch an application and specify the test mode (see
“Launching an application” on page 28).
The HST launches the application in the mode you speci-
fied, and the Summary Results screen appears.
2 Press the Configure navigation key.
The Summary Settings menu appears, listing the key
settings for the application you launched. Figure 17 illus-
trates the settings for the Terminate 1G Optical Ethernet
application when running a Layer 3 Traffic test.
NOTE:
If you change settings while transmitting traffic, results will
not reflect the true state of the circuit. Always stop traffic
before changing settings.
Figure 17 Summary Settings Menu
To Next Page
Loading...
