Chapter 1 Getting Started
Configuring your test
34
HST-3000 Ethernet Testing User’s Guide
3 Go to the Network Visibility menu, then specify the
following:
The settings are specified.
Setting Parameters
Unit Identifier Use this setting to specify a
unique ID for the instrument,
which will be used during loop-
back and multiple streams test-
ing, and during the JDSU
Discovery process. The factory-
assigned ID appears by default.
Unit Discoverable Select one of the following:
– Yes. Allows other JDSU
instruments on the same sub-
net with the JDSU Discovery
feature to detect the instru-
ment, and enables the dis-
covery feature on your
instrument.
– No. Prevents other JDSU
instruments from detecting
the instrument, and disables
the discovery feature on your
instrument.
Source IP*
1
(Layer 2 Traffic only)
1. These settings only appear if you are running a Layer 2 Traffic test.
They are required to run the Asymmetric RFC 2544 test, or to use
the JDSU Discovery feature. If you are running layer 3 or layer 4
tests, the settings are specified on the IP Init configuration menu.
Enter the source IP address car-
ried by all traffic generated by
your unit.
Subnet Mask*
1
(Layer 2 Traffic only)
Enter the subnet mask.
Default Gateway*
1
(Layer 2 Traffic only)
Enter the default gateway
address.
To Next Page
Loading...
