JDS Uniphase HST-3000 - Config Status; Config Step View

Chapter 8 SAMComplete Testing
Managing test results
244 HST-3000 Ethernet Testing User’s Guide
Config Status The Config Status results provide pass (green check mark) or
fail (red x) verdicts for every step of the configuration test, for
each service.Figure 49 provides an example of the Config
Status results.
Config Step View The Config Step View provides a graphic representation of the
step test, for the selected service. The measured frame loss
ratio, frame transfer delay, and frame delay variation for the
highlighted step (scroll between steps using up/down arrow)
are provided in the table above the graph. The CIR, EIR, and
Policing Transmit rates are also included in the graph along
with the configured SLA thresholds. Figure 50 provides an
Figure 49 Multi-stream Config Status screen