Chapter 6 Multiple Streams Testing
Copying a stream’s settings to all streams
190
HST-3000 Ethernet Testing User’s Guide
5 If you are transmitting layer 4 streams, use the right arrow
key to go to the L4 Config per Stream menu, and then
specify the layer 4 characteristics for each stream.
For an explanation of each of the settings, see step 3 on
page 170 of “Specifying the traffic mode and ports”. For
an explanation of the ATP Listen Port setting, see “Under-
standing the ATP Listen Port” on page 164.
6 If you need to specify other settings for the test, use the
left and right arrow keys to go to the appropriate configu-
ration menu; otherwise, press the Home key to return to
the Summary Results screen.
The traffic streams are configured.
Copying a stream’s settings to all streams
After you configure a traffic stream, you can optionally copy
the stream’s settings to the remaining streams.
To Next Page
Loading...
