Chapter 3 Ethernet Testing
MAC-in-MAC testing
HST-3000 Ethernet Testing User’s Guide
113
4 If you need to specify other settings for the test, use the
left and right arrow keys to go to the appropriate configu-
ration menu; otherwise, press the Home button to return
to the Main screen.
The MiM filter settings are specified.
Transmitting
MiM traffic
Before you transmit layer 2 traffic over a MiM trunk, you must
configure the traffic. For instructions, see:
– “Initializing the link for MiM testing” on page 107
– “Specifying frame characteristics” on page 107
– “Configuring the traffic load” on page 109
– “Filtering MiM traffic” on page 109
– “Specifying OAM settings” on page 95
After you specify the layer 2 settings, you are ready to transmit
and analyze the traffic.
Rx BERT Pattern
(If Rx = Tx is No)
To analyze frames with a
specific BERT pattern,
select one of the following:
– 2^23-1
– Inv 2^23-1
– 2^31-1
– Inv 2^31-1
– All Ones
– All Zeros
– User Defined, and
then enter the pattern.
User Payload
(if Rx BERT Pattern is User
Defined)
Enter the pattern carried
in the traffic you are ana-
lyzing.
Setting Parameters
To Next Page
Loading...
