Chapter 8 SAMComplete Testing
Specifying settings
HST-3000 Ethernet Testing User’s Guide
231
3 On the Summary Settings list, select SAM Complete and
then select Symmetric.
Symmetric is used when only round-trip throughput and
SLA parameters are defined because upstream and
downstream transmission is identical as the test stream is
being looped back to the source at the destination.
The SAMComplete test is enabled.
Specifying settings
After enabling the test, you must specify the settings used for
the tests. The available SAMComplete settings vary
depending on whether you are running a single-stream or
multi-stream application.
Loading a
saved
configuration
If you have previously specified settings and saved them as a
configuration profile, you can load the config profile. This
allows consistent setups and quicker startup time.
To load a configuration
1 Press the Save soft key.
2 Select Load Config.
3 Choose a profile from the list, and then press OK.
Specifying test
settings
To specify test settings
1 If you have not previously specified settings or wish to
change settings, Press the Configure navigation key.
2 Press the Settings soft key, and then select SAMCom-
plete Settings.
A list of settings appears.
To Next Page
Loading...
