Chapter 8 SAMComplete Testing
Managing test results
HST-3000 Ethernet Testing User’s Guide
243
Managing test results
As each test runs, the results are updated on the screen.
There are several categories of results available for viewing.
Viewing test
results
The SAMComplete test has five categories of test results:
– Summary
– Config Status
– Config Step View
– Config Step Details
– Performance
To view test results
– Press the Display soft key, select SAMComplete, and
then choose a result category.
Summary results
The Summary results provide a pass/fail indication for each
service in sequential configuration test and the performance
test where all services are tested in parallel. (Figure 48 on
page 242 shows this screen at the beginning of the test.) The
progress and status of each test is displayed in the progress
bar under each test. The global test status is displayed in the
upper right of the screen. After all tests finish, the global
verdict appears in the upper left of the screen.
To Next Page
Loading...
