JDS Uniphase HST-3000 - Filtering Received Traffic Using Layer 4 Criteria

Chapter 5 TCP/UDP Testing
Configuring layer 4 traffic
HST-3000 Ethernet Testing User’s Guide
175
Filtering
received traffic
using layer 4
criteria
You can specify settings that determine which packets will
pass through the layer 4 receive filter and be analyzed and
reported in the test result categories. Traffic that does not
pass filter criteria is not reported in the test result categories
To specify layer 4 filter criteria
1 If you haven’t already done so, launch the IPv4 or IPv6
Terminate application for the circuit you are testing (see
“Launching an application” on page 28), and then select
the Layer 4 Traffic test (see “Selecting a layer 4 TCP/UDP
test” on page 165).
2 Press the Configure navigation key.
A configuration menu appears.
3 Do the following:
TIPS:
– If you want to use the JDSU Discovery feature to popu-
late the filter, be certain to Enable the filter.
– If you want to analyze all received traffic, verify that the
Ethernet Filter settings are all Don’t Care, and that the
IP and L4 filters are both Disabled.
– If you want to analyze only layer 4 traffic, be certain to
Enable the L4 filter.