Chapter 4 IP Testing
Establishing a PPPoE session
128
HST-3000 Ethernet Testing User’s Guide
5 If you need to specify other settings for the test, use the
left and right arrow keys to go to the appropriate configu-
ration menu; otherwise, press the Home button, and then
do the following:
– If you are initializing a 1G or 100M optical Ethernet
link, press the Action soft key, and then select
Laser On.
– Verify that the Sync LED is green (indicating that the
link is active).
– Display the IP Config results category to observe test
results associated with the IP connection.
The connection is established.
Establishing a PPPoE session
In addition to the settings you specify to establish an Ethernet
link, when establishing a PPPoE session (available for IPv4
Terminate applications only), you also specify settings that
allow you to log in to the PPPoE peer. The settings indicate
whether you want your unit to emulate a PPPoE client or
server, and provide the user name, password, and other infor-
mation required to establish the session.
Default Gateway Enter the default gateway
address.
Preferred DNS
(PING and Traceroute
only)
Specify the address for the pre-
ferred DNS server.
Alternate DNS
(PING and Traceroute
only)
Specify the address for an alter-
nate DNS server.
Setting Parameters
To Next Page
Loading...
