Chapter 4 IP Testing
Establishing a PPPoE session
HST-3000 Ethernet Testing User’s Guide
129
To establish a PPPoE session
1 If you haven’t already done so, launch the electrical IPv4
terminate application (see “Launching an application” on
page 28), and then select a test (see the appropriate
procedure below):
– “Selecting a layer 3 IP test” on page 120
– “Selecting a layer 4 TCP/UDP test” on page 165
2 Press the Configure navigation key.
A configuration menu appears.
3 Do the following:
a Use the left and right arrow keys to go to the Test
Mode menu (see Figure 27).
b Set the Data Mode to PPPoE.
4 Go to the Link Init menu, and specify the settings required
to initialize an Ethernet link (see “Initializing the link for
Ethernet testing” on page 47
).
Figure 27 Test Mode configuration menu
To Next Page
Loading...
